YKE5405M 5 Phase Open-Loop Stepper Drive

YKD2822M is high performance digital step drive based on YAKO's new 32-bit DSP technology. It's suitable for 86-130mm(NEMA34-57) 2 phase open-loop stepper motors.

YKD2204PA open-loop stepper drive feature for 32-bit DSP control, low noise and superior vibration performance, with over voltage, under voltage etc. fault protection.

MCC800P is a PCI-based motion control card for controlling stepper motors and servo systems. Motion planning through ARM and FPGA, pulse commands can be output, which can control 1-8 axes servo or stepper motor at the same time. The maximum frequency of each axis is 4MHz, and the 8-axis encoder input signal can be detected. It supports linear and circular interpolation, supports trapezoidal and S-shaped acceleration and deceleration point-to-point motion control, and supports speed/positoion change during motion. The position command can be output by single pulse (pulse + direction) or double pulse (CW + CCW pulse); it can be a differential output circuit or a single-ended output circuit.
MCC800P matched terminal board has multiple general I/Os, supports high-speed position latching and position comparison output. External bus I/O expansion greatly satisfies customers' various control requirements for I/O.

This product is equipped with a dynamic link library under Windows XP/Win7, which is convenient for customers to write their own application software. At the same time, it provides motion debugging software, which can demonstrate the function of this card, it also can be used to tests the operation of motion control cards, motors and drives and motion platforms.

Typical Application:

Widely used in PCB industry, semiconductor packaging industry, electronic processing industry, sheet metal processing industry, testing industry, such as: PCB drilling machine, PCB punching machine, solid crystal machine, ultrasonic wire bonding machine.

Stepper drive auto-setup measures motor parameters and configures motor current control and anti-resonance gain settings. The high voltage drive uses ac input 90 to 240 Vac and output current is selectable from 0.6 to 2.5 A/phase (peak of sine).

The AC stepper drive is powered from 24 to 50V and is intended for use with step motors designed to handle a high bus voltage of 340VDC.

110mm Series 2 Phase Open-loop Stepper Motor  Step accuracy: 5% Temperature: 80℃Max Ambient temperature: -20℃-+50℃ Insulation resistance: 100MΩ Min 500VDC Pressure resistance: 500VAC 1 minute Radial runout: Maximum 0.02mm (450g load) Axial runout: Maximum 0.08mm (450g load) Specification Model Step Angle (°） Motor Lenth (L) Holding Torque (N.m) Rated Current (A) Resistance (Ω） Inductance (mH) Rotor Inertia (g.cm²） Weight (kg) Motor Leads YK110HB115-06A     1.8 115 12 6.0 0.44 4.9 7200 6.0 4 YK110HB150-06A 1.8 150 18 6.0 0.8 9.4 10900 8.4 4 YK110HB201-08A 1.8 201 27 8.0 0.6 11.0 16200 11.0 4 Dimensions Dimensions Model  Shaft Diameter D(mm)  Shaft Type (mm) Shaft Length L1 (mm)    YK110HB115-06A  16 Key 4*4*20 35 YK110HB150-06A  16 Key 4*4*20 35 YK110HB201-08A  16 Key 4*4*20 35 Motor connection