Tel : +86 18148038996
Email : zhangwenying@yankong.com
Brand:
YakoItem no.:
YKD3505MPayment:
100% T/T payment before deliveryProduct origin:
Made in ChinaProduct weight:
0.65kgLead Time:
Normally 7 workdaysYKD3505M Yako 3 Phase Open-Loop Stepper Motor Drive
Our stepper motor drivers are suitable for various models of three-phase 42-86mm (NEMA17-34) hybrid stepper motors with currents below 5.5A. Using servo-like control circuit and superior software algorithm, it has superior performance in terms of smoothness, noise and vibration. Smooth and accurate current control technology greatly reduces motor heating.
Features:
Application:
Mainly used in laser cutting machine, laser welding machine, laser marking machine, locking screw machine, medical equipment, robot, dispensing machine, electronic equipment, engraving machine.
YKD3505M Microstep Setting
YKD3505M Current Setting
Terminal Introduction
Symbol |
Function |
Specification |
PWR |
Power indicator |
When power on, the green indicator lights up. |
ALARM |
Fault indicator |
When over current, under voltage or over voltage, the red indicator lights up. |
PU+ |
Pulse signal + |
Connect with the signal power supply, 5V~24V can drive, need to connect a current limiting resistor with PU- when >5V |
PU - |
Pulse signal - |
Effects on falling edge, the motor moves a step when the pulse goes from high to low. The input resistance is 220Ω. It requires: low level 0~0.5V, high level 4~5V, pulse width>2.5us. |
DR+ |
Direction signal + |
Connect with the signal power supply, 5V~24V can drive, need to connect a current limiting resistor with DR- when >5V |
DR - |
Direction signal - |
Used to change motor direction, requirements: low level 0~0.5V, high level 4~5V, pulse width>2.5us. |
MF+ |
Motor free signal + |
Connect with the signal power supply, 5V~24V can drive, need to connect a current limiting resistor with MF- when >5V |
MF+ |
Motor free signal - |
When effective (low level), the motor coil current is turned off and motor free |
- V |
Power supply - |
DC20- 50V |
+V |
Power supply + |
|
U |
Motor connection |
|
V |
||
W |
||
Reserved |
N |
Reserved |
Notice: 1. Do not reverse the power supply, input voltage should not exceed DC50V.
2.The input control signal level is 5V. The current limiting resistor needs to be connected when>5V.
(Please refer to page 4 for connection)