YKD2205PE Yako Advanced DSP Technology Bus Type Stepper Drive

YKD2205PE Yako Advanced DSP Technology Bus Type Stepper Drive

YKD2205PE is a high-performance bus-type stepping driver based on a new generation of 32-bit DSP technology. The voltage range is 24~50V. Choose to be powered by a single power supply. Suitable for motors whose current is lower than 2A and 42mm (NEMA17). Strong anti-interference ability, almost no vibration and noise.

Features:

• 32-bit DSP technology, smooth and low vibration
• Voltage range 24~50V
• Current is adjustable, up to 2A
• Based on 100BASE-TX Ethernet transmission standard, transmission rate up to 100Mbps, full-duplex communication
• Support CoE (CANopen over EtherCAT), complies with CiA 402 standard
• Support Cyclic Sync Position, Profile Position, Profile Velocity, Homing multiple working modes
• Dual-port RJ45 connector for EtherCAT communication
• 5 channels of optically isolated input interface, 5V~24V compatible input
• 2 optical isolation output interface
• Microstep 400~51200 settings, electronic gear is supported
• Smooth and accurate current control, low motor heating
• Protection against overvoltage, undervoltage, overcurrent, etc.
• The default is suitable for 42mm(NEMA17) motor, 28mm motors can be adapted by adjusting the relevant parameters of the drive.

Application: 

Mainly used in new energy industry, battery equipment, photovoltaic equipment, 3C non-standard automation equipment, electronic equipment, robots and medical equipment, laser equipment, textile equipment, plotters etc. automation equipment.